Customer Service (800) 367-8912     Tech Support (800) 942-5872
$5.95reg $6.95 - saving of 15%
    Plumbers Neck Putter Adapter
    Model: H003

Product Name Price Qty
Plumbers Neck Putter Adapter
In stock
  • 0

Click on the image above to enlarge


These precision cast, stainless steel adapters are designed to fit virtually any putter with a 0.370" parallel bore 90° socket and transform it into an entirely different putter regardless of manufacturer. Each has an attractive neutral bead blast finish and three styles to choose from. Directions: Simply test fit stem into the putter’s socket as it should be a tight fit. If it does not fit, lightly hand sand stem until it is snug. Apply quick setting epoxy to stem, seat and align adapter and allow the epoxy to harden. Lastly, install the new shaft – it’s that simple!

The Plumbers Neck adapter converts a RH putter designed to have a compound triple bent shaft with the proper lie/offset and accept a straight shaft. Weighs 44g. Creates a 72 degree lie angle.

Customer Reviews

Items 1 to 25 of 25 total

per page

    Write Your Own Review

    Only registered users can write reviews. Please, log in or register

    Questions on Plumbers Neck Putter Adapter

    Sort by Descending
    • From Eric at 4/29/2015 6:34 AM
      • Hello,

        What is the bore in the plumber's neck socket? 0.370 or smaller?

        Thank you
      • Eric,

        It is 0.370" for both the hosel bore for the shaft and the stem that goes into the socket of the head.
      • Do you find this question helpful?  Yes   No
    • From Jared at 5/28/2015 9:16 PM
      • Can the lie angle be bent more upright or flatter after install?
      • Jared,

        Even though the hosel adapters are made of stainless steel and usually bendable, you are relying on the strength of the two screws to take the brunt of the force required to alter the lie angle. Therefore we would not recommend attempting to alter the lie.
      • Do you find this question helpful?  Yes   No
    • From LARRY LYNCH at 9/13/2015 9:00 PM
      • I have an Odyssey MetalX #6 CS center shaft putter. Can i install this adapter to give me some offset .

        Thanks, Lash
      • Lash,

        I believe that putter has a post where the shaft fits over. Plus the Plumber's neck hosel will only work on putters with a 90 degree socket, not on this model where the lie angle is already built in. If you wanted to create an offset, I might suggest the Apollo AP46OP-001 shaft shown here:
      • Do you find this question helpful?  Yes   No
    • From Zach at 3/31/2016 10:33 PM
      • What is the lie angle when installed?
      • Zach,

        It is 72 degrees.
      • Do you find this question helpful?  Yes   No
    • From Ollie at 8/3/2016 12:05 PM
      • Hi,

        What is the total length of the adapter?

        Thanks, Ollie
      • Ollie, It is 3 1/8" long.
      • Do you find this question helpful?  Yes   No

    Ask Your Own Question

    Back to the product page
    Normally ships in 1-2 business days
    Model # Weight UPC
    H003-001 0  
    Shipping Length (inches) Shipping Width (inches) Shipping Height (inches) Shipping Weight (pounds)
    0 0 0 0
      Related products for you