Intech Crossbar Golf Travel Support Rod

Customer Service (800) 367-8912     Tech Support (800) 942-5872

New Hireko Golf Fall Accessories

$4.95reg $4.95
    Slant Hosel Putter Adapter
    Model: H002

Product Name Price Qty
Slant Hosel Putter Adapter
$4.95
In stock
    
  • 0
$0.00


Click on the image above to enlarge

Details

These precision cast, stainless steel adapters are designed to fit virtually any putter with a 0.370" parallel bore 90° socket and transform it into an entirely different putter regardless of manufacturer. Each has an attractive neutral bead blast finish and three styles to choose from. Directions: Simply test fit stem into the putter’s socket as it should be a tight fit. If it does not fit, lightly hand sand stem until it is snug. Apply quick setting epoxy to stem, seat and align adapter and allow the epoxy to harden. Lastly, install the new shaft – it’s that simple!

The Slant Hosel adapter converts a RH putter designed to have a compound triple bent shaft with the proper lie and reduced or non-offset configuration and accept a straight shaft. Weighs 44g. Creates a 72 degree lie angle.

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Questions on Slant Hosel Putter Adapter

Sort by Ascending
  • From Andrew at 8/15/2017 4:58 AM
    • What size shaft is needed for this adapter?
    • Andrew,

      These will accept a standard 0.370" parallel tip shaft.
    • Do you find this question helpful?  Yes   No
  • From David at 5/18/2017 11:05 AM
    • How deep is the bottom post? I.E. how far into the putter head is it able to go?
    • David,

      The depth that this product goes into a socket is 0.55".
    • Do you find this question helpful?  Yes   No
  • From Derek at 1/13/2014 5:24 AM
    • What is the diameter of the bottom of post.
    • Derek;

      The bottom post (portion that fits inside the head) is 0.370" diameter.
    • Do you find this question helpful?  Yes   No
  • From Mike at 9/5/2013 6:00 PM
    • Can this be used on a LH putter for the conversion i.e. turned 180 deg around?
    • Mike,

      It was designed as a RH product only. If you did place it into a LH putter with a 90 degree socket, it would create negative offset.
    • Do you find this question helpful?  Yes   No
  • From john at 8/12/2013 8:21 AM
    • can these be bent/adjusted for lie/offset?
    • John,

      The are constructed from 431 stainless, so from a material standpoint could be bent. From a practical side, they may not as you are relying on the little over 1/2" post to absorb all the force after it has been epoxied into place.
    • Do you find this question helpful?  Yes   No

Ask Your Own Question





Back to the product page
Normally ships in 1-2 business days
Model # Weight UPC
H002-001 0  
Shipping Length (inches) Shipping Width (inches) Shipping Height (inches) Shipping Weight (pounds)
0 0 0 0
    Related products for you