Orlimar TriMetal Fairway Woods and Hybrids

Customer Service (800) 367-8912     Tech Support (800) 942-5872

Orlimar Golf V18 Driver

34 Item(s)

  • Grid 
  • List 
  • Set Ascending Direction
    per page
    1. Uneekscraper Grip Tape Remover

      Model# BRP06

      Uneekscraper Grip Tape Remover

      This scraper is the fastest and safest way to remove grip tape from graphite or steel shafts. Equipped with ergonomic handle. Learn More
    2. Steel Shaft Sanding Belt - 1" X 42"

      Model# MIT012-001

      Steel Shaft Sanding Belt - 1" X 42"

      Replacement belt for 1" x 42" belt sanders. The coarse grit belt is perfect for steel shaft tip abrasion. Learn More
    3. Spiral Deburring Roll and Mandrel

      Model# SDRM

      Spiral Deburring Roll and Mandrel

      Starting at: $8.95

      Use in drill to clean out hosels after re-shafting or prior to assembly for best bond. Kit contains mandrel and 5 deburring rolls. Learn More
    4. Shaft Cut-Off Wheel

      Model# MIT016-001

      Shaft Cut-Off Wheel

      6 inch diameter x 0.35" thick wheel cuts both steel & graphite shafts efficiently. 1/2" arbor hole. Learn More
    5. Rubber Vise Shaft Clamp

      Model# RAVC-001

      Rubber Vise Shaft Clamp

      Rubber Vise Shaft Clamp is used with a shop vise to protect the shaft and hold the club securely in place during assembly and disassembly procedures. Learn More
    6. Rod Saw Blade

      Model# GG12-50T

      Rod Saw Blade

      The ideal tool to cut graphite and composite shafts safely and efficiently with the long-lasting tungsten carbide cutting edge. Fits any standard 12" hacksaw frame. TIP: Wrap the shaft with making tape where you want to cut, mark the tape and cut along the mark to prevent fraying or splintering. Learn More
    7. Replacement Hook Blades

      Model# MIT052-001

      Replacement Hook Blades

      These are replacement hooked knife blades for standard utility knives. These are available 5 to a pack. Learn More
    8. Replacement Grip Remover Needle

      Model# MIT028-001

      Replacement Grip Remover Needle

      Loosens the grip for easy removal by injecting solvent through needle. Works in conjunction with the Dynacraft Grip Remover Gun and needle-save hose. Sold individually. Learn More
    9. Replacement Deburring Rolls

      Model# SDRR

      Replacement Deburring Rolls

      Starting at: $6.95

      Set of 5 replacement rolls for use with SDRM Spirl Deburring Mandrel. Use in drill to clean out hosels after re-shafting or prior to assembly for best bond. Learn More
    10. Pure Installation Gun

      Model# RP2000

      Pure Installation Gun

      The installation of PURE Grips requires no adhesive tapes or solvents. Using Pure Grip’s proprietary quick-connecting tools, the simple power of air pressure installs their grips as securely as any adhesive tape. Once installed on a steel or graphite shaft, the grip provides optimal stability while the elasticity of the rubber combines with friction to create "rubber memory," ensuring the grip will not loosen or slip. (Note: Pure Grip recommends an air compressor between 50-150 psi, and that has at least 5 gallon tank. You could install a quick connect on the gun if you choose to, but it’s not necessary.) Learn More

    34 Item(s)

  • Grid 
  • List 
  • Set Ascending Direction
    per page