Questions on Apollo Shadow FL Graphite Golf Shafts

Sort by Date Helpfulness

• From JOSEPH pinitsch at 12/6/2013 4:39 PM
  • I ORDERED THIS SHAFT WANTING A STIFF SHAFT IT IS LISTED AS R/S FLEX HOW DO YOU TRIM IT TO BE A STIFF SHAFT IS IT LENGTH THIS IS FOR A DRIVER
  • Joseph,
    
    For an R-flex driver, all material would be taken off of the butt end. For stiff flex, you would tip trim 1" and then butt trim to length.
  • Do you find this question helpful?  Yes   No
• From Leo Jansen at 4/18/2016 12:01 PM
  • When trimming for 3-6 hybrids for R flex the trimming chart shows H1 & H2 tip trim at 0. The XF hybrid head chart shows length steps of 1/2" just like the irons. Just want to confirm that no tip trimming is correct for 3-6 hybrids.
    
    Thanks.
  • Leo,
    
    The Acer XF hybrids weigh the same as the corresponding numbered iron. So if you are trimming the shafts for the #3 hybrid, treat this as if were a 3-iron for both tip trimming and length. In this case 0.5" tip trim and 39.5" for men's standard length. The H1 and H2 designations were for special lightweight hybrids that required a 0.370" or 0.355" taper tip shaft and were lighter than even a 1-iron. Those are rare to find, but they did exist, therefore we needed to add them to the chart just in case a customer encountered one.
  • Do you find this question helpful?  Yes   No
• From Tim Monahan at 6/5/2016 4:27 PM
  • When do you expect the A/L iron shafts to be back in stock?
  • Tim,
    
    ETA is June 23rd.
  • Do you find this question helpful?  Yes   No
• From Steve Brown at 4/30/2017 8:54 AM
  • How much do I trim off the tip (driver) of the Apollo Shadow graphite for a senior flex? I plan to cut it total length of 45 inches.
    Thank you
  • Steve,
    
    If you bought the A/L wood shaft, then tip trim 1" for a senior flex driver.
  • Do you find this question helpful?  Yes   No
• From Harold at 5/9/2017 8:03 PM
  • I have a Adams Super S Idea 3 hybrid. Do I treat it like a 3 iron for tip and length?
    
    Thanks
    
    
  • Harold,
    
    You will need to weigh the head. You would treat the club for tip trimming and length as a 3-iron only if the head weighs the same as a 3-iron (@242 grams). I believe it will be less though. If the weight is closer to 235g, treat as a 2-iron and if closer to 229g, treat as a 1-iron.
  • Do you find this question helpful?  Yes   No