Hireko Forum   Search   Recent Topics  Back to home page  Register /  Login

Iron shaft taper--smaller than 0.355   Forum Index -> Clubmaker to Clubmaker Author Message 04/10/2006 13:52:29     Subject: Iron shaft taper--smaller than 0.355 biggee4994@sbcglobal.net Joined: Apr 10, 2006 Messages: 1 Offline Does anyone know if there was an iron shaft taper smaller in diameter than the modern 0.355? The shafts on a set of Wilson "Billy Casper Shotmakers" appear to be smaller than 0.355----I haven't measured yet. Any reshafting suggestions? Thanks---Gary. 04/10/2006 14:34:22     Subject: Re:Iron shaft taper--smaller than 0.355 Jeff Summitt Joined: Jan 13, 2006 Messages: 2541 Offline Gary: Those could very well be a .320" taper tip shafts, which are not available anymore. If they are, then you can use a .355" taper tip shaft by going into the hosel about 1 1/4". You will most likely need to step-taper the hosel with a T-size (1 1/4"), U-size (3/4" deep) and a 3/8" bit (3/8" down). Test fit the .355" taper tip shaft as needed. Jeff Summitt   Forum Index -> Clubmaker to Clubmaker Go to:  Select a forum   Technical Discussion - Equipment ------------- Ask Hireko Clubmaker to Clubmaker OEM Discussion   Let's Hear From You ------------- Testimonials Suggestions & Feedback   e-Commerce Announcements ------------- Press Releases Specials & Promos

Powered by JForum 2.1.4 © 2005 - Rafael Steil