| Author |
Message |
|
|
ialwaysgolf2@gmail.com
Joined: Dec 22, 2008
Messages: 19
Offline
|
Hi Jeff, can you tell me what shaft tip is used in the Callaway Steelheads? Need to reshaft a set for a guy and not sure--do they still slit the tip and drive them in to fit then put a bore thru plug in or are they taper with a plug or std. with a plug? Cannot seem to find any info on them. Thanks JR
|
|
|
 |
|
|
Jeff Summitt
Joined: Jan 13, 2006
Messages: 2541
Offline
|
JR:
If these are the original Steelheads and not the II or III, then they will take a parallel tip .335" shaft. This link may help on the shaft / plug installation:
http://blog.hirekogolf.com/wordpress/?page_id=17
Jeff Summitt
|
|
|
|
|
|
ialwaysgolf2@gmail.com
Joined: Dec 22, 2008
Messages: 19
Offline
|
Hi and thanks Jeff, you sure the irons are 335 parallel? this is a wood shaft, I have just been emailed with a .370 parallel answer also--thanks for any and all help
JR
|
|
|
|
|
|
Jeff Summitt
Joined: Jan 13, 2006
Messages: 2541
Offline
|
JR:
I was thinking you were speaking about the woods, not the irons. But use a .370" parallel tip iron shaft. You may have to run a 9.4mm or a 3/8" drill bit inside the hosel to clean out the old epoxy and remove the small tapered portion at the very bottom of the hosel.
Jeff Summitt
|
|
|
|
|
|
ialwaysgolf2@gmail.com
Joined: Dec 22, 2008
Messages: 19
Offline
|
Thanks Jeff,
|
|
|
|
|
|
Register
Login
