Dynacraft Bench Ruler Soleplate - All Questions

Dynacraft Bench Ruler Soleplate
Dynacraft Bench Ruler Soleplate
Set Descending Direction
At what lie angle does this set the club to measure it against?

Is it 60*?

Question by: Eric H on Feb 4, 2016, 11:04 AM

Because it is a small pivot point, it is not set at angle angle per se. This is what allows it to be used for any club in the set including putters.
Answer by: Richard Lin on Feb 5, 2016, 11:02 AM
What size of screws would you use to anchor the device to a bench?
Question by: Lance M Matteo on Feb 9, 2022, 6:47 AM
I have used standard 1 5/8" drywall screws.
Answer by: Jeff Summitt on Feb 9, 2022, 7:08 AM
So when soling different clubs, do you use the very first contact point or do you move the club until it’s centered on the pin? Does it matter if the lie angle is different?
Question by: Ryan on Feb 20, 2022, 2:19 PM
Hi Ryan,

Make sure the shaft is centered on the 48" ruler, then use the first contact point on the sole. It won't matter what the lie of the club is as long as the shaft is centered.
Answer by: Jeff Summitt on Feb 21, 2022, 5:45 AM

3 Item(s)

Show per page