Shaft Extenders for Graphite and Steel Shafts - All Questions
Shaft Extenders for Graphite and Steel Shafts
SKU
PGGS
I need a shaft extender for a tour ad di 7tx and an extender for a Kai Li 6TX ? can you tell me what size extenders I need? I dont have a measuring tool handy.
Question by: Stephen Salata on Jun 15, 2023, 3:00 PM
Unfortunately, there is not a spec the manufacturer publishes for the inside diameter of a graphite shaft; it will have to be physically measured (inside calipers will work too). Even it it were published, it could change depending upon how much was trimmed from the butt and if the shaft had a parallel butt section or a constant taper profile.
Answer by: Jeff Summitt on Jun 16, 2023, 5:56 AM
Will these be compatible with Hireko graphite counterweights? The CW's go too deep into the extensions I have on hand.
Question by: James Manning on Apr 30, 2024, 11:32 AM
Hi James,
Unfortunately, not. The wall diameters of the extenders are thicker than a typical graphite shaft for strength and the Hireko counterweight will be too large.
Unfortunately, not. The wall diameters of the extenders are thicker than a typical graphite shaft for strength and the Hireko counterweight will be too large.
Answer by: Jeff Summitt (Admin) on Apr 30, 2024, 12:18 PM
Check items to add to the cart or
